Community Forums

Been there bruise very easy when I was at 20 mg for three years the top layer of my skin would peel away if I bumped it would stick it back down put g...

Have had same issue tried every product out there with same result. Have used flow vent this will clear up rash and stop itch is a steroid that is in...

Have not tried this but did read on another site that a mixture of one part vinegar to two parts water will do the job not sure if it would be suitabl...

Thanks Marcie for your encouragement will take your words to heart. Have of course tried to use the wafer as is that cannot be done although at first ...

Will discuss with family Dr. If it is an allergy to the adhesive used in wafers I cannot see what a solution would be. For sure I need to use somethi...

Unfortunately this province is without a dermatologist as the last one passed away will have to travel to another province. Am able to control the ra...

I believe anti fungal is only useful if the rash is a yeast infection usually very itchy and raised little bumps in Canada can be treated with difucan...

I have a prescription for Flovent if the rash gets very bothersome it works well but realize it is not a solution as it can thin out your skin just li...

That is a good idea as most samples they will send are cut to fit so would have a little bit to use as a test. Have tried using duoderm sheet and a c...

I have but usually a few samples you are sent and used on the other side of the abdomen just are not enough time to induce a response I will have to t...

A bit of both have found I need the calimine to protect the skin from the wafer it does the job for two days then the hot prickly feeling returns and ...

They came through with the order yesterday by courier unfortunately did not include a couple of one piece . Will send off a email asking for some .

Thanks for taking time to answer.

Thanks Marcie will give that method a try

I use a precut so that is not the problem I just am guessing that the placement is on the skin and not on top of the stoma once it hits that moldable ...

That is one bonus 😂

Thanks John will look it up for sure.